|
AEROQUIP® OIL SAMPLING VALVE
With a turn of the knob, the valve allows inline sampling of system fluids without system shutdown, in little time, and without the worry of fluid contamination.
For best results, the HC-FD15 oil sampling valves should be installed in dynamic fluid lines in low pressure and return lines. If only one sampling valve point can be chosen it should be in the return line, upstream of any return line filter. This will ensure a representative sample of the present condition of all components in the system.
The Aeroquip® oil sampling valve is designed for use with engine oil, lubricating oil, transmission fluid, and hydraulic fluids in mobile construction equipment, military vehicles, trucks, and stationary equipment.
Operation:
Remove metal dustcover on discharge port. Discharge approximately 200ml of oil to flush valve by turning knurled knob 1/4 turn to the right. Dispose of this sample in the appropriate manner. Locate clean oil sample bottle under the discharge port.
(Sample bottles are usually supplied by the oil analysis lab). Turn the knurled knob 1/4 turn to the right until bottle is filled to the desired level. The knob can be backed off to throttle the rate of flow. When the bottle is filled, let go of the knurled knob and the valve will close automatically. Replace the metal dustcover wrench tight.
Construction:
Corrosion resistant plated steel with brass internal components and Buna-N seal.
|
|
